Milestone XProtect Enterprise 2014 Manuel d'utilisateur télécharger pdf (Page 84)

Milestone XProtect

Enterprise

2014

Administrator's Manual

www.milestonesys.com

Advanced configuration

Record Keyframe Only

Keyframes stored at specified intervals record the entire view of the

camera, whereas the following frames record only pixels that

change; this helps greatly reduce the size of MPEG files. Select the

check box if you only want to record keyframes.

Record All Frames on

Allows you to make exceptions if you have selected to record

keyframes only.

 Motion Detection: Select this to record all frames when

motion is detected. Two seconds after the last motion (see

"Motion detection & exclude regions" on page 96) is

detected, the camera will return to recording keyframes

only.

 Event: Select this to record all frames when an event

occurs and until another event occurs. Requires that events

have been defined, and that you select start and stop

events in the neighboring columns.

Use the Configure events list, located below the other

fields to define events that suit your needs.

 Motion Detection & Event: Select this to record all frames

when motion is detected, or when an event occurs and until

another event occurs. Remember to select start and stop

events in the neighboring columns.

 Schedule only: Select this to record all frames according to

the camera's speedup schedule (see "Speedup" on page

135) only.

Start Event

Use when recording on Event or Motion Detection & Event.

Select required start event. The camera will begin recording all

frames when the start event occurs.

Stop Event

Select required stop event. The camera will again only recording

keyframes when the stop event occurs.

Audio recording

When you configure video and recording (see "About video and recording configuration" on page 64)

for specific cameras, you can determine whether audio should be recorded or not. Your choice applies

for all cameras on your system.

Name

Description

Always

Always record audio on all applicable cameras.

Never

Never record audio on any cameras. Note that even though audio is

never recorded, it is still be possible to listen to live audio in the

Smart Client.

If you record audio, it is important that you note the following:

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 217 218

Commentaires sur ces manuels

Pas de commentaire

Milestone XProtect Enterprise 2014 Manuel d'utilisateur Page 84

Commentaires sur ces manuels

Produits connexes et manuels pour Logiciel Milestone XProtect Enterprise 2014