Milestone XProtect Enterprise 2014 Manuel d'utilisateur télécharger pdf (Page 111)

Milestone XProtect

Enterprise

2014

Administrator's Manual

www.milestonesys.com

111

Advanced configuration

Before you specify input for a hardware device, verify the hardware device recognizes sensor

operation. Most hardware devices can show this in their configuration interfaces, or via CGI script

commands. Also check the release notes to verify that input-controlled operation is supported for the

hardware device and firmware used.

To add and/or configure a hardware input event, do the following:

1. In the Management Application navigation pane, expand Advanced Configuration, then

expand Events and Output. Right-click Hardware Input Events and select Enable New

Input Event.

2. In the Hardware Input Event Properties window's list of hardware devices, expand the

required hardware device to see a list of pre-defined hardware input.

3. Select the required types of input to use them as events. The types of input often vary from

camera to camera. If motion detection (see "Motion detection & exclude regions" on page 96)

is enabled in the system for the relevant camera, note the input type System Motion

Detection, which lets you turn detected motion in the camera's video stream into an event.

Note that some types of input are mutually exclusive. When you select one type of input, you

may therefore note that other types of input become unavailable for selection.

4. For each selected type of input, select required properties (see "Hardware input event" on

page 118). When ready, click OK, or click the Add button to add a timer event (on page 113)

to the event you have just created.

5. Save your configuration changes by clicking Save in the yellow notification bar in the upper-

right corner of the Management Application.

Add a hardware output

With hardware output, you can add external output units, such as lights, sirens and door openers, to

your system. Once added, output can be activated automatically by events or detected motion, or

manually by client users.

Before you specify output, verify that sensor operation is recognized by the hardware device with

which you are going to use the output. Most hardware devices are capable of showing this in their

configuration interfaces, or via CGI script commands. Also check the release notes to verify that

output-controlled operation is supported for the hardware device and firmware used.

To add a hardware output event, do the following:

1. In the Management Application navigation pane, expand Advanced Configuration, then

expand Events and Output. Right-click Hardware Output and select Add New Output.

2. In the Hardware Output Properties window's list of hardware devices, select the required

hardware device, and click the Add button below the list.

3. Specify required properties (see "Hardware input event" on page 118).

4. Click OK.

5. Save your configuration changes by clicking Save in the yellow notification bar in the upper-

right corner of the Management Application.

For information about how to configure automatic activation of hardware output when events occur,

see Configure hardware output on event (on page 113). You configure output for manual activation in

1 2 ... 106 107 108 109 110 111 112 113 114 115 116 ... 217 218

Commentaires sur ces manuels

Pas de commentaire

Milestone XProtect Enterprise 2014 Manuel d'utilisateur Page 111

Commentaires sur ces manuels

Produits connexes et manuels pour Logiciel Milestone XProtect Enterprise 2014