Milestone XProtect Enterprise 2014 Manuel d'utilisateur télécharger pdf (Page 110)

Milestone XProtect

Enterprise

2014

Administrator's Manual

www.milestonesys.com

110

Advanced configuration

Name

Description

Output control on event:

Hardware output can be activated automatically when events occur.

For example, when a door is opened (hardware input event), lights

are switched on (hardware output).

When configuring the output control, you can select between all

output and events defined in XProtect Enterprise. You are not

limited to selecting output or events defined on particular hardware

devices. You can use a single event for activating more than one

output.

Before you configure events of any type, configure general event handling, such as which ports

XProtect Enterprise should use for event data. Normally, you can just use the default values, but it is a

good idea to verify that your organization is not already using the ports for other purposes. See

Configure general event handling (on page 114).

Before you specify use of hardware input and hardware output units on a hardware device, verify that

sensor operation is recognized by the hardware device. Most hardware devices are capable of

showing this in their configuration interfaces, or via CGI script commands. Also check the XProtect

Enterprise release notes to verify that input and output controlled operations are supported for the

hardware device and firmware used. If you are using several XProtect Enterprise servers in a

master/slave setup, input and output on a specific hardware device should be defined on one of the

servers only. Do not define the same input or output on the same hardware device on several servers.

This applies even for dedicated input/output devices.

You do not have to configure hardware input units separately, any hardware input units connected to

hardware devices are automatically detected when you add the hardware devices to XProtect

Enterprise. The same goes for hardware output, but hardware output does require some simple

configuration in XProtect Enterprise.

If you want to configure hardware output and automatically trigger output when events occur, so

that, for example, lights are switched on when a door is opened or when motion is detected in video,

see Add a hardware output (on page 111) and Configure hardware output on event (on page 113).

When you are ready to configure events, see Add a hardware input event (on page 110), Add a

generic event (on page 112), and Add a manual event (on page 112). If you want to use timer events

with your other events, see Add a timer event (on page 113).

Add an analytics event

To add an analytics event, do the following:

1. Expand Events and Output, right-click Analytics Events and select Create New.

2. Specify required properties (see "Analytics event" on page 117). Click OK.

3. Save your configuration changes by clicking Save in the yellow notification bar in the upper-

right corner of the Management Application.

Add a hardware input event

With hardware input events, you can turn input received from input units attached to hardware devices

into events in your system.

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 217 218

Commentaires sur ces manuels

Pas de commentaire

Milestone XProtect Enterprise 2014 Manuel d'utilisateur Page 110

Commentaires sur ces manuels

Produits connexes et manuels pour Logiciel Milestone XProtect Enterprise 2014