Milestone XProtect Advanced VMS 2014 Manuel d'utilisateur télécharger pdf (Page 80)

Milestone XProtect

Advanced

VMS 2014

Administrator's Manual

www.milestonesys.com

Management Client elements

The content of the Settings tab is determined by the selected hardware, and varies depending on the

type of hardware. For some types of hardware, the Settings tab displays no content at all or read-only

content.

For information about the Settings tab for remote servers, see Settings tab (remote server) (on page

82).

PTZ tab (video encoders)

On the PTZ tab, you can enable PTZ (Pan/Tilt/Zoom) for video encoders. The tab is available if the

selected device is a video encoder or if the driver supports both non-PTZ and PTZ cameras.

You must enable the use of PTZ separately for each of the video encoder's channels on the PTZ tab

before you can use the PTZ features of the PTZ cameras attached to the video encoder.

Not all video encoders support the use of PTZ cameras. Even video encoders that support the use of

PTZ cameras may require configuration before the PTZ cameras can be used. It is typically the

installation of additional drivers through a browser-based configuration interface on the device's IP

address.

PTZ tab, with PTZ enabled for two channels on a video encoder

Enable PTZ on a video encoder

To enable the use of PTZ cameras on a video encoder, do the following on the PTZ tab:

1. In the list of devices connected to the video encoder, select the Enable PTZ box for the

relevant cameras:

2. In the PTZ Device ID column, verify the ID of each camera.

3. In the COM Port column, select which video encoder's COM (serial communications) ports to

use for control of the PTZ functionality:

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 296 297

Pas de commentaire

Milestone XProtect Advanced VMS 2014 Manuel d'utilisateur Page 80