Milestone XProtect Advanced VMS 2014 Manuel d'utilisateur télécharger pdf (Page 91)

Milestone XProtect

Advanced

VMS 2014

Administrator's Manual

www.milestonesys.com

Management Client elements

Before you specify use of external input units on a device, verify that the device itself recognize the

sensor operation. Most devices can show this in their configuration interfaces, or via Common

Gateway Interface (CGI) script commands.

Input devices are added automatically when you add hardware to the system. They are per default

disabled, so you must enable them before use, either as part of the Add Hardware wizard or

afterwards. Input devices do not require separate licenses. You can use as many input devices as

required on your system.

For information about supported hardware, see the supported hardware page on the Milestone

website.

Enabling/disabling and renaming of individual devices take place on the recording server hardware.

See Enable/disable devices via device groups (on page 93).

For all other configuration and management of cameras, expand Devices in the Site Navigation pane,

then select Input. In the Overview pane, you group your input devices for an easy overview. Initial

grouping is done as part of the Add hardware wizard.

You can configure input devices on these tabs:

 Info tab (see "Info tab (devices)" on page 95)

 Settings tab (see "Settings tab (devices)" on page 97)

 Events tab (see "Events tab (devices)" on page 114)

Activate input manually for test

With the rules feature, you define rules that automatically activate or deactivate input or you can

activate them manually and check the result in the Management Client:

1. In the Overview pane, select the relevant input device.

2. Activate the input on the physical device.

3. In the Preview pane, see if the indicator lights up green. Then the input device works.

About output devices

On many devices you can attach external units to output ports on the device. This allows you to

activate/deactivate lights, sirens, etc. through the system.

You can use output when creating rules. You can create rules that automatically activate or deactivate

outputs, and rules that trigger actions when the state of an output is changed.

Output can be triggered manually from the Management Client and XProtect Smart Client.

Before you specify use of external output units on a device, verify that the device itself can control the

device attached to the output. Most devices can show this in their configuration interfaces, or via

Common Gateway Interface (CGI) script commands.

1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 296 297

Pas de commentaire

Milestone XProtect Advanced VMS 2014 Manuel d'utilisateur Page 91