Milestone XProtect Advanced VMS 2014 Manuel d'utilisateur télécharger pdf (Page 75)

Milestone XProtect

Advanced

VMS 2014

Administrator's Manual

www.milestonesys.com

Management Client elements

 a recording server on a remote site in a Milestone Interconnect setup:

o XProtect Corporate or

o XProtect Expert or

o Arcus-enabled hardware.

See Add hardware (on page 75) to read about how to add hardware to your system.

Add hardware

You have several options for adding hardware for each recording server you have authorized on your

system.

Important: If your hardware are located behind a NAT-enabled router or a firewall, you may need to

specify a different port number and configure the router/firewall so it maps the port and IP addresses

that the hardware uses.

The Add Hardware wizard helps you detect hardware like cameras and video encoders on your

network and add them to the recording servers on your system. The wizard also helps you add remote

recording servers for Milestone Interconnect setups. Only add hardware to one recording server at a

time.

1. To access Add Hardware, right-click the required recording server and select Add Hardware.

2. Select one of the wizard options (see below) and follow the instruction on the screen.

3. After installation, you can see the hardware and it's devices in the Overview pane.

Name

Description

Express (Recommended)

The system scans automatically for new hardware on the recording

server's local network.

Select the Show hardware running on other recording servers

check box to see if detected hardware is running on other recording

servers.

You can select this option every time you add new hardware to your

network and want to use it in your system.

You cannot use this option to add remote systems in Milestone

Interconnect setups.

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 296 297

Pas de commentaire

Milestone XProtect Advanced VMS 2014 Manuel d'utilisateur Page 75