Milestone XProtect Essential 2014 Manuel d'utilisateur télécharger pdf (Page 62)

Milestone XProtect

Essential 2014

Administrator's Manual

www.milestonesys.com

Advanced configuration

of a second between state checks). For information about which I/O hardware devices require polling,

see the release notes.

Configure hardware devices

Once you have added hardware devices, you can specify/edit device-specific properties, such as the

IP address, which video channels to use, which COM ports to use for controlling attached PTZ (pan-

tilt-zoom) cameras, whether to use 360° lens technology, etc.

1. Expand Advanced Configuration, expand Hardware Devices, right-click the relevant

hardware device, and select Properties.

2. Specify Name and video channels, Network, device type and license (see "Network, device

type, and license" on page 63), PTZ device (see "PTZ device (properties)" on page 64), and

360° lens (see "Fisheye" on page 101) properties as required.

3. Save your configuration changes by clicking Save in the yellow notification bar in the upper-

right corner of the Management Application.

Delete hardware devices

IMPORTANT: If you delete a hardware device, you not only delete all cameras, speakers and

microphones attached to the hardware device. You also delete any recordings from cameras on the

hardware device.

1. Expand Advanced Configuration, expand Hardware Devices, right-click the hardware

device you want to delete, and select Delete Hardware device.

2. Confirm that you want to delete the hardware device and all its recordings.

3. Save your configuration changes by clicking Save in the yellow notification bar in the upper-

right corner of the Management Application.

4. Restart the Recording Server service.

Alternately, you can also consider disabling the individual cameras, speakers or microphones

connected to the hardware device:

1. Expand Advanced Configuration, expand Hardware Devices, and expand the relevant

hardware device.

2. Right-click the camera, microphone or speaker that you want to disable, and select Disable.

3. Save your configuration changes by clicking Save in the yellow notification bar in the upper-

right corner of the Management Application.

4. Restart the Recording Server service.

About replacing hardware devices

If you need to, you can replace a hardware device that you have added and configured on your

system with a new one, for example to replace a physical camera on your network.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 188 189

Pas de commentaire

Milestone XProtect Essential 2014 Manuel d'utilisateur Page 62