Milestone XProtect Essential 2014 Manuel d'utilisateur télécharger pdf (Page 109)

Milestone XProtect

Essential 2014

Administrator's Manual

www.milestonesys.com

109

Advanced configuration

2. In the Hardware Input Event Properties window's list of hardware devices, expand the

required hardware device to see a list of pre-defined hardware input.

3. Select the required types of input to use them as events. The types of input often vary from

camera to camera. If motion detection (see "Motion detection & exclude regions" on page 97)

is enabled in the system for the relevant camera, note the input type System Motion

Detection, which lets you turn detected motion in the camera's video stream into an event.

Note that some types of input are mutually exclusive. When you select one type of input, you

may therefore note that other types of input become unavailable for selection.

4. For each selected type of input, select required properties (see "Hardware input event" on

page 114). When ready, click OK, or click the Add button to add a timer event (on page 110)

to the event you have just created.

5. Save your configuration changes by clicking Save in the yellow notification bar in the upper-

right corner of the Management Application.

Add a hardware output

With hardware output, you can add external output units, such as lights, sirens and door openers, to

your system. Once added, output can be activated automatically by events (see "Overview of events

and output" on page 107) or detected motion, or manually by client users.

Before you specify output, verify that sensor operation is recognized by the hardware device with

which you are going to use the output. Most hardware devices are capable of showing this in their

configuration interfaces, or via CGI script commands. Also check the release notes to verify that

output-controlled operation is supported for the hardware device and firmware used.

To add a hardware output event, do the following:

1. In the Management Application navigation pane, expand Advanced Configuration, then

expand Events and Output. Right-click Hardware Output and select Add New Output.

2. In the Hardware Output Properties window's list of hardware devices, select the required

hardware device, and click the Add button below the list.

3. Specify required properties (see "Hardware input event" on page 114).

4. Click OK.

5. Save your configuration changes by clicking Save in the yellow notification bar in the upper-

right corner of the Management Application.

For information about how to configure automatic activation of hardware output when events occur,

see Configure hardware output on event (on page 111). You configure output for manual activation in

clients as well as for automatic activation on detected motion individually for each camera (see

"Output" on page 96).

Add a manual event

With manual events, your users with required rights can trigger events manually from their clients.

Manual events can be global (shared by all cameras) or tied to a particular camera (only available

when the camera is selected). You can use manual events for a wide variety of purposes, for example:

1 2 ... 104 105 106 107 108 109 110 111 112 113 114 ... 188 189

Commentaires sur ces manuels

Pas de commentaire

Milestone XProtect Essential 2014 Manuel d'utilisateur Page 109

Commentaires sur ces manuels

Produits connexes et manuels pour Logiciel Milestone XProtect Essential 2014