Milestone XProtect Professional 2014 Manuel d'utilisateur télécharger pdf (Page 160)

Milestone XProtect

Professional

2014

Administrator's Manual

www.milestonesys.com

160

Advanced configuration

Name

Description

Enable internet access

Select the check box if the server should be accessible from the

internet through a router or firewall. If you select this option, also

specify the public (“outside”) IP address and port number in the

following fields. When using public access, the router or firewall

used must be configured so requests sent to the public IP address

and port are forwarded to the local (“inside”) IP address and port of

the XProtect Professional server.

Internet address

Specify a public IP address or hostname for use when the system

server should be available from the Internet.

Internet port

Specify a port number for use when the system should be available

from the Internet. The default port number is 80. You can change

the port number if needed.

Max. number of clients

You can limit the number of clients allowed to connect at the same

time. Depending on your XProtect Professional configuration and

the performance of the hardware and network used, limiting the

number of simultaneously connected clients may help reduce

server load. If more than the allowed number of simultaneously

connected clients attempt to log in, only the allowed number of

clients will be allowed access. Any clients in excess of the allowed

number will receive an error message when attempting to log in.

By default, a maximum of ten simultaneously connected clients are

allowed. To specify a different maximum number, simply overwrite

the value.

Tip: To allow an unlimited number of simultaneously connected

access clients, type 0 (zero) in the Max. number of clients field.

A four-minute session timeout period applies for client sessions on

XProtect Professional. In many cases, client users may not notice

this at all. However, the session timeout period will be very evident

if you set the Max. number of clients value to 1. When that is the

case, and the single allowed client user logs out, four minutes must

pass before it will be possible to log in again.

Local IP ranges

You can specify IP address ranges which your system should recognize as coming from a local

network. This can be relevant if different subnets are used across your local network.

1. Click the Add button.

2. In the Start Address column, specify the first IP address in the range.

3. In the End Address column, specify the last IP address in the range.

Repeat if you want to add other local IP address ranges.

1 2 ... 155 156 157 158 159 160 161 162 163 164 165 ... 217 218

Commentaires sur ces manuels

Pas de commentaire

Milestone XProtect Professional 2014 Manuel d'utilisateur Page 160

Commentaires sur ces manuels

Produits connexes et manuels pour Logiciel Milestone XProtect Professional 2014